Quantcast
Channel: Data converters
Viewing all articles
Browse latest Browse all 38440

Forum Post: RE: Questions about TX-SDK-V2 EVB

$
0
0

Hi sir,

thanks for your reply .

sorry sir, you are absolutely right sir. Now with the Win xp I could get the GUI working.

Now to get start up,Individual Device Evaluation to test  LM96570 and LM96551. I followed Ultrasound Tx Evaluation Kit(TX_SDK_V1) User’s Guide 2.4 section.

1)Means power up sequence

2) launching app ,

3)connect, reset(enable and then disable), pll(enable and then disable),

4)after setting 2.4.5 point in user guide settings for beamformer controls,

5)connect, start Tx,

6)enabling high voltage pulser.

But I could not observe the output mentioned in 2.4.9 in oscilloscope at pulser o/p PS0-7 left side pin. I  Just observed noise at PS0-7 pins, and I tried to probe P0-7, N0-7 pins of beamformer which was same. Let me know sir, still any more information needed for my hardware set up.

could not getting where I am doing wrong. Please help me sir, it is very important for me.

And I observed the beamformer IC getting heated much than pulser, switch when I supplied power supplies especially 3.3v. Is it common or any problem is there?.


Thank you very much, waiting for your reply.


regards,

chandu.


Viewing all articles
Browse latest Browse all 38440

Latest Images

Trending Articles



Latest Images

<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>