Nishant, ONE crucial question though, can I Drive DRV2604L with only PWM connected? you see as I cant access the middle BALL pin of SDA without HDI PCB development which is very costly! [JP] We do have a DGA package (seen below) that will be easier to mount onto a board. Unfortunately, you cannot use the just PWM without setting the Mode register (Address 0x01) to PWM and Analog input. If you were to use the device without I2C communication it should operate using all default register settings. kindly have a look and tell me if you think they are fit and are ERMs!! [JP] They both meet the minimum resistance requirements and our device will be able to drive both of these ERM's at 3V. Best Regards, Javier Palomo
↧