Forum Post: RE: Android Driver of TSC2007
Hi JaePhil, Android is based on the Linux kernel, so normally you cannot find a driver only for Android. Here is a link to the latest Linux driver for TSC2007 in the Linux Kernel 3.18:...
View ArticleForum Post: Unable to get correct calibration results
Hi, I am using ADS7843 /XPT2046 ( SPI based touch controller ) interfaced with AM335x custom board, i am trying to calibrate the LCD using "ts_calibrate" tool in linux, but what i observed that we are...
View ArticleForum Post: RE: Beamforming Problems
Jakob, I notices image noise (like rain) over the BW mode on Accuvix V20. In service manual I found there could be a problem with BF board: BD-348-BF (BF BD Accuvix V10) I can send you images. Did you...
View ArticleForum Post: Candidate Replacement for MSC1210Y5
Hi, Due to some unresolved memory corruption issue and almost till the EOL of the above mentioned part, I would like to look for a newer microcontroller which could replace it. The brief requirements...
View ArticleForum Post: RE: AFE5808 VCA_PDN_CH register not found on table
Hi Dylan, 1. Yes, you make a good point as the datasheet is not clear with these names. I will get back to you with that answer. 2. I will have to measure this as it is not in the datasheet, but the...
View ArticleForum Post: RE: Unable to get correct calibration results
Hi Nitesh, Have you tried the test program "ts_test" from tslib after calibration? Could you see correct trace when you run this test program? Andy
View ArticleForum Post: RE: Looking for a good touchscreen testbed
Hi Devin, Sorry for my late reply. What do you mean by "sliding"? Is it an one-finger gesture, like "flick"? If yes, the "sliding" gesture could be detected by some software IP, which is called...
View ArticleForum Post: RE: Platform data for ADS7843 in linux
Hi Nitesh, Sorry for my late response. I will try to give you the answer tomorrow morning. Andy
View ArticleForum Post: RE: Android Driver of TSC2007
Hi Andy, Thanks for your information. I hope that it will be the right solution for android driver of TSC2007 . Thanks. JP CHUNG
View ArticleForum Post: RE: AFE5808 VCA_PDN_CH register not found on table
Chuck, Thanks. I would wait for your answer. Best Regards Dylan
View ArticleForum Post: RE: Android Driver of TSC2007
Hi JaePhil, I have verified this driver in my Linux development kit quite a few times with a TSC2007EVM and it is working very well. Andy
View ArticleForum Post: RE: Unable to get correct calibration results
Hi Andy, I did tried the test program "ts_test", but i was not able to get the correct trace. I resolved the problem, by making below changes in the driver , i was able to get correct pattern (figure...
View ArticleForum Post: RE: Unable to get correct calibration results
Hi Andy, I did tried the "ts_test" program, but was unable to get the correct trace. I resolved the problem by making below changes in the ads7846 .c linux driver, i was able to get the correct pattern...
View ArticleForum Post: LM96570 -- SPI message length
Hi Team, I am using an application with a custom SPI controller than accepts 8, 16 and 32 bit SPI responses. Some LM96570 messages are 22-bits. What would the expected behavior be if the controller...
View ArticleForum Post: Three Phase PWM Motor Driver using 8051 core
Hi, can somebody help me with a sample design of DRV8332 with 3 PWM?
View ArticleForum Post: RE: AFE5808 VCA_PDN_CH register not found on table
Hi Chuck, Any update? Dylan
View ArticleForum Post: RE: LM96570 -- SPI message length
Hello Rob, This is the answer I got from the experts: "The incoming data length has to match the length of register to be written in order to play safe. If customers need to stuff the data stream into...
View ArticleForum Post: RE: Looking for a good touchscreen testbed
Imagine that you had an image on the screen and you wanted to feel its texture. You would slide your finger across the screen to feel it. I guess a better word would be rub. That is what I mean. I know...
View ArticleForum Post: RE: Looking for a good touchscreen testbed
Hi Devin, From my point of view, the "rub" gesture is more like a firmware / software job and it doesn't require some special touch function from the touch device. All you need is just some precise...
View ArticleForum Post: touch tv
i am electronic student, i am want to make a touch tv , but i have nom ida about it can u please help me...
View Article