Forum Post: AFE5801- how to write to register, SPI based?

Hello:

I searched the forums for a LabVIEW example. Specifically, I am looking for an example that shows how to write to or read the register of TI AFE5801 ADC.

I am using pg. 2 & pg. 20 of the AFE5801 datasheet as a guideline. Is the TI AFE5801 ADC based on SPI serial bus?  In the interim, I will code assuming SPI based implementation (assuming MISO= SDOUT, MOSI= SDATA, SEN= CS).

I will greatly appreciate if someone could show me example read/ write code or pseudo code (LabVIEW is not necessary, more interested in sequence).

Thank you.

Best Regards,

Mohit